To minimize the risk of exposure to asbestos.
Asbestos-Containing Materials (ACM)
Any materials containing more than one percent asbestos. A few common examples of ACM include: pipe and boiler insulation (TSI), sprayed on fire proofing, troweled or acoustical plaster, floor tiles and mastic, linoleum, transite shingles, transite lab bench tops, roofing materials, wall and ceiling plaster, joint compound, ceiling tiles, blackboards, mastics, and gasket materials.
Presumed Asbestos-Containing Materials (PACM)
Any surfacing material, TSI, or resilient floor coverings present in buildings constructed prior to 1980 are assumed to contain greater than one percent asbestos unless they have been sampled to negate the presence of asbestos.
Small Operations and Maintenance Activity
Any activity conducted by the University’s in-house trained asbestos workers that requires the abatement of less than 3 linear feet or 3 square feet of known or assumed asbestos containing materials.
Suspect Asbestos-Containing Materials
Any material that may contain more than one percent asbestos, but has not been sampled and tested to determine its asbestos content.
Asbestos-Containing Flooring Material (ACFM)
This group includes vinyl asbestos tile (VAT), linoleum and/or the mastic that adheres the VAT or linoleum to the sub-floor.
All asbestos-containing materials in University owned buildings and facilities should be managed to minimize the exposure of University personnel, students, guests, visitors, and contract employees to asbestos. All activities that may impact, disturb or dislodge asbestos fibers are to be conducted and abated in a manner consistent with the procedures below and in compliance with applicable State and Federal asbestos abatement regulations.
- Environmental Health & Safety (EH&S) shall write and maintain an Asbestos Management Plan which establishes asbestos operations, maintenance, and inspection procedures.
- Prior to the start of any renovation and/or demolition project, excluding small operations and maintenance activities, EH&S must be contacted to coordinate a survey for suspect and known asbestos containing materials in the project area. Any suspect asbestos containing material identified in the project area, that may be impacted or disturbed, must be either sampled and tested to determine its asbestos content or assumed to contain asbestos and managed as an asbestos containing material. Small operations and maintenance activities do not need to be coordinated through EH&S.
- Any materials known or identified to be ACM that will be impacted or disturbed as a result of renovation or demolition activity must be properly abated in accordance with Department of Environmental Quality Regulations, and Oregon Occupational Safety and Health Administration Asbestos Standards. EH&S will determine the proper abatement methods to be used.
- Asbestos abatement projects, excluding small operations and maintenance activities, must be coordinated by EH&S and supervised and monitored by an Oregon Full-Scale Supervisor. Small operations and maintenance activities do not need to be supervised and monitored unless they are completed in public areas. Examples of public areas include, but are not limited to, offices, classrooms, auditoriums, conference rooms, hallways, bathrooms, living spaces, common building areas and laboratories. Any exceptions to the supervision and monitoring requirement must be determined on a case by case basis by EH&S.
- Any University employee who may disturb ACM or PACM as part of their job shall receive asbestos awareness training and annual refresher training thereafter.
- University employees who are required to perform asbestos abatement activities must be certified by the State of Oregon as asbestos abatement supervisors or workers. All abatement activities need to be monitored by a State of Oregon asbestos abatement supervisor.
- Any University employee or contractor that identifies any damaged, suspect or known asbestos containing materials shall notify EH&S immediately upon identification. EH&S will assess the situation, arrange for the appropriate corrective actions, and notify the regulatory agencies as necessary.
- Asbestos consultants that are contracted by the University to prepare asbestos abatement specifications, conduct facility surveys for ACM, monitor asbestos abatement projects and analyze bulk and air asbestos samples shall be pre-approved by OUS.
- Asbestos abatement contractors that are contracted by the University to complete asbestos abatement projects shall be pre-approved by OUS.
- Any ACFM adhered to a concrete sub-floor will be removed prior to the installation of new flooring materials. Any ACFM adhered to a wood sub-floor will either be removed or a new underlayment will be secured to the wood sub-floor through the VAT or linoleum prior to the installation of new flooring materials.
- As a general rule, the cost of required asbestos abatement is to be funded by the organization that has the maintenance responsibility for the building. For example, Campus Operations is responsible for funding asbestos abatement in all education and general fund buildings, unless it is a departmental requested elective improvement. Other organizations such as Housing, the Memorial Union, Agricultural Experiment Stations, etc. are responsible for funding asbestos abatement in their buildings. However, the cost of any associated asbestos abatement will be incorporated into the cost of any renovation or remodeling project regardless of its size or funding source.